Microsens RS232 Specifiche Scaricare il pdf (Pagina 48)

19'' 6U Chassis page 48/71

• Set the object: mgnt2CtrlChassisShutDown

Location: ...\microsens \mgnt2\mgnt2Hardware \mgnt2controls\

• Using a command in the CLI

• Enter the command shutdown (or sd) in the CLI

In all the cases, the LEDs of the MGNT are switched OFF when the MGNT is properly

stopped. Then, you can unplug the MGNT and plug it again in the MS430502M chassis.

It is necessary to wait at least 10 seconds before plugging again the MGNT.

Visual indications:

The colour sequence of the front panel LEDs are:

MGNT

SW LED: Off (few seconds) > Orange (less than 1 second) > Green

HW LED: Red (about 1 second) > Green

Generic slot MS

Refer to relevant MS User Manual.

End procedure

Power Off/On

The last method of reset is to power down the MS430502M chassis for a few moments

and power up again. This is traffic affecting and all equipped modules are reset. The

manager is unavailable for approximately 35 seconds.

Procedure

There is no on/off switch on the MS430502M chassis, powering down/up is achieved by

disconnecting/connecting the -48V supply(s) on the front panel.

• Power Down:

Before powering down the complete chassis, it is mandatory to stop the MGNT

software.

There are several ways to stop the MGNT software:

• Using the test button on the front panel. Push up the test button for 10

seconds.

• Using a SNMP object

Set the object mgnt2CtrlChassisShutDown

Location: ...\microsens \mgnt2\mgnt2Hardware \mgnt2controls\

• Using a command in the CLI. Enter the command shutdown (or sd) in the CLI.

In all the cases, the LEDs of the MGNT are switched OFF when the MGNT is

properly stopped.

Remove the -48V supply(s) on the front panel.

MICROSENS GmbH & Co. KG - Küferstraße 16 - 59067 Hamm - Tel. +49 2381/9452 0 - Fax 9452 100 - www.microsens.com

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 70 71

Nessun commento

Microsens RS232 Specifiche Pagina 48